Progress, slow and steady.

Posts : 31 Join date : 2020-12-04 Age : 56

So I finally finished my build.

I used these instructions plus the ones from GGflex to get the electronics up:
https://github.com/EEMLLC/GGFlex/blob/master/Media/PDF/ElectronicsInstructions.pdf
plus
https://www.zyltech.com/arduino-cnc-shield-instructions/

I used the zyltech instructions, installed the IDE, and pushed grbl to the aurdino. Then I loaded UGS (universial gcode platform) and I can get the motors to move in the x, y and z..

Slow progress is still progress.

Posts : 53 Join date : 2021-03-17

apr67 wrote:: So I finally finished my build.

I used these instructions plus the ones from GGflex to get the electronics up:
https://github.com/EEMLLC/GGFlex/blob/master/Media/PDF/ElectronicsInstructions.pdf
plus
https://www.zyltech.com/arduino-cnc-shield-instructions/

I used the zyltech instructions, installed the IDE, and pushed grbl to the aurdino. Then I loaded UGS (universial gcode platform) and I can get the motors to move in the x, y and z..

Slow progress is still progress.

Have you been able to cut anything on yours yet?